Foaming of good price and quality reflective hot melt marking paint from China refers to bubbles of air, solvent vapor and other gases or both formed during the construction of good price and quality reflective hot melt marking paint from China. Such bubbles can disappear or exist forever during the drying process of good price and quality reflective hot melt marking paint from China.

1. The main reasons for blistering of good price and quality reflective hot melt marking paint from China are as follows: 1. There are cavities on the concrete surface. 2. The surface of hot-melt marking paint dries too fast. 3. The construction temperature is too high.

2. Precautions for blistering of good price and quality reflective hot melt marking paint from China include

1) Select the appropriate primer.

2) Use hot melt marking paint with slightly dry surface.

3) Proper construction temperature shall be controlled.

Precipitation of good price and quality reflective hot melt marking paint from China during Construction

Good price and quality reflective hot melt marking paint from China is the most widely used road marking paint in China, which has been used for more than ten years in China. When using a good price and quality reflective hot melt marking paint from China, on the one hand, it should be convenient for the construction team to use, because it can standardize the driving vehicles and make the road layout more reasonable; On the other hand, it is required to have good reflective effect, bright color and certain durability.

Good price and quality reflective hot melt marking paint from China is added to the hot melt kettle, and the fluidity is still poor after long heating. The marked line flow adjustment is poor, and there are many pits and sanding on the surface. And with the increase of cooking time, the mouth of the hot melt kettle will emit a lot of odor and pungent smoke, sometimes a slight explosion will occur in the hot melt kettle, and the quartz sand, Fufen and other filler materials in the kettle will settle seriously, forming slag like coating that is difficult to flow out of the hot melt kettle. These phenomena are analyzed as follows:

Reasons for poor fluidity: The resin acts as a "solvent" in the melt good price and quality reflective hot melt marking paint from China. If the resin is too little, it means that there is too little "solvent" to drive the flow of filler materials. No matter how high the temperature is, the fluidity of the paint is poor. The marked line has poor flow adjustment, and the surface has many pits and sanding.