Operating instruction

Use steps:

(1) Put the gas cylinder on the hot melt trolley, close all the valves, and connect the coal and chlorine pipeline.

(2) hang the hopper required for construction, plug in the gas pipeline, and check the microbead distributor system.

③ Adjust the pointer at the datum waterline at the construction site. (Align the alloy strip of the blade with the waterline in the hopper, and then align the pointer with the waterline)

(4) Turn on the gas cylinder switch, ignite the ignition gun, and then gradually point the fuel tank heater, the hopper burner, the hopper burner, check whether the burner is working properly, after preheating, put the paint from the hot melt kettle, and fill the bead box with glass beads.

(5) a pointer on the line, put down the hopper, open the door, put the paint in the hopper, and then open the doumen, push forward delimit, beads and cloth to switch on at the same time, the construction of injection into the hopper coating at any time, time to ensure three-fourths of coating in the hopper, a barrel after use closed hopper, closed gate and ball valves, feeding again.