The good price and quality heat reflective paint from China manufacturer is mainly applied by brushing and rolling, and can also be sprayed. The construction shall be carried out in strict accordance with the construction instructions and shall not be diluted with water.

1、 Basic construction process of good price and quality heat reflective paint from China manufacturer

The construction process of good price and quality heat reflective paint from China manufacturer is as follows: cleaning of new asphalt pavement or maintenance of old pavement → cleaning and curing of pavement → coating the first layer of coating → spreading the first layer of anti-skid granular material → curing → coating the second layer of coating → removing the second layer of anti-skid granular material → curing → removing the plastic film and cleaning → opening the traffic.

2、 Construction operation of good price and quality heat reflective paint from China manufacturer

1）. Implement traffic control and set up traffic signs that are eye-catching.

2）. The asphalt film on the surface of newly-built asphalt pavement will affect the bonding performance of good price and quality heat reflective paint from China manufacturer, so cleaning treatment must be carried out before the construction of new asphalt pavement coating; This operation is not necessary for the old asphalt pavement, but if there are grease and other stains on the surface, corresponding treatment is required. At the same time, repair the diseases that affect the strength of pavement structure.

3）. Use the high-pressure air blower to blow the loose fine particles and dust on the road from the inside to the outside, seal the road markings with adhesive tape, and cover the outside of the construction with geotextile or plastic film to prevent pollution during construction.

4）. Mix and prepare paint. Pay attention to the amount of hardener added during mixing.

5）. The first layer of coating shall be applied according to the optimal coating amount determined by the indoor test, and the coating amount shall be 0.4kg/m2. The coating construction method shall be determined according to the project scale. Roll coating is suitable for small area construction, and spraying is suitable for large area construction.

6）. After the construction of the first layer of coating, the anti-skid granular material shall be spread immediately. The spreading amount is 0.5kg/m2. If the blower is used to blow the granular material, it may cause the granular material to fly away to the outside of the construction section. The construction area can be enclosed by the wall protection board. Curing shall be carried out after the first layer of anti-skid granular material is removed. The curing time is 30 (summer) ~60min (winter).

7）. After the first coating is hardened and the anti-skid granular material is fixed, the second coating and anti-skid granular material shall be applied in the same way. The coating amount of the second coating is 0.4kg/m2, and the particle distribution amount is 0.2kg/m2.

After the good price and quality heat reflective paint from China manufacturer is coated, the final curing of the pavement shall be carried out for 30min in summer and 1H in winter. At the same time, clean the contaminated parts in time and remove the plastic film. If the paint is stuck to the marking line beyond the scope, it shall be scraped off with a patch shovel and other tools. After the pavement reaches a certain strength, the adhesive tape will be removed and the traffic will be opened.