Reflective hot melt marking paint marking is to heat the reflective hot melt marking paint in a hot melt machine. The temperature after melting is controlled between 180 degrees Celsius and 220 degrees Celsius, and it is fully stirred for about 10 minutes before coating. Cold coating marking is a method of coating directly without heating the paint, also known as normal temperature marking. Reflective hot melt marking paint is generally used for road surface, or concrete surface, asphalt parking lot. However, with people's pursuit of improvement, epoxy floors began to be widely used in parking lots, and epoxy floors could not withstand the high temperature of hot melt marking, so most of the current parking lots use normal temperature marking.

The main steps of reflective hot melt marking paint are as follows:

1. Enclose the construction site to prevent the marking line from being damaged when it is not finalized, and to protect the safety of construction personnel.

2. Clean up the construction site. This is an indispensable step for all reflective hot melt marking paint marking construction. After all, debris on the ground will affect the marking quality of parking spaces. (Sweeper, blower, broom, etc. can be used for cleaning work. Tools that can be used according to the situation)

3. Stakeout, if the parking space is marked with reflective hot melt marking paint, then the stakeout is relatively simple, if it is marked with cold coating, then use cowhide glue to stick to the edge of the marking position, and the workload is relatively large. (Pay attention to the specifications of parking spaces)

4. Reflective hot melt marking paint heating, pay attention to the temperature can not be too high or high or low, 180-220 °, otherwise it will affect the quality of the marking and the color of the marking.

5. Paint construction (a key step), pay attention to the marking tool is there is no problem, the discharge is not normal.

6. Check and accept the construction results, repair the unexpected parts.